Hitec D930SW: Speed Demon Servo, Steel & Digital Muscle! Precision Control!
Alright partner, are you tired of the same old same old Well, hold your horses because this ain't your grandma's widget This is a full-throttle experience, a symphony of awesome packed into one sleek package Picture this, you're cruising down the highway of life, wind in your hair, the sun on your face, and this bad boy right here This thing is the ultimate wingman, the life of the party, the champion of your dreams Seriously, it's so good it'll make you wanna yodel off a mountain Get yours today and prepare to have your mind blown Its not just a purchase its a statement, a rebellion, a straight up good time So saddle up and let's ride
D930SW Digital High Speed Dual Ball Bearing Steel Gear Standard Servo from Hitec - HRC36930
The power of Hitec’s D-Series servos continues with the introduction of the next Premium Class trio: the D930SW, D954SW and D955TW. As with the entire “D” line, these technologically-advanced servos are powered by 32-bit MCU (Microcontroller Unit) and 12-bit ADC (Analog to Digital Converter) industrial science and possess Smart Sense engineering with rapid, high resolution response. Their unprecedented programmability and wide-voltage capabilities deliver the most progressive, leading-edge performance for all your radio control needs. Built with incredibly durable steel gears, the D930SW is the perfect upgrade from the popular HS-8330SH servo.
Features:
- Programmable PWM Digital Amplifier
- 32-Bit MCU with 12-Bit ADC Circuitry
- 4096 Resolution
- 1M Cycle Long Life Potentiometer
- Wide Operating Voltage (4.8 ~ 8.4 Volts DC)
- Dual Ball Bearing Supported Output Shaft
- 25-Tooth Output Spline
- Coreless Metal Brush Motors
- Nylon Reinforced Plastic Upper and Lower Case
- Diamond Cut Aluminum Heat Sink Center Case
- Dust Resistant and Splash Proof Case
Includes:
- 1x D930SW digital high speed dual ball bearing steel gear standard servo
- Servo horns and hardware
Tech Note: In order to program the Fail-Safe on this servo you will need to purchase the Hitec field programmer sold separately. The metal servo horn will fit any Hitec servos that have a '+' stamped on top of the output shaft.
